FUEL SYSTEM
5-5
CARBURETOR
REMOVAL/INSTALLATION
Remove the air cleaner elbow (page 5-4).
Set a commercially available tube clamp to the fuel
tube.
Drain the fuel completely (page 5-3).
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
•
Keep heat, sparks, and flame away.
•
Handle fuel only outdoors.
•
Wipe up spills immediately.
GOVERNOR ROD/THROTTLE RETURN SPRING
INSULATOR
PACKING
CARBURETOR PACKING
CARBURETOR INSULATOR
FUEL TUBE
REMOVAL/INSTALLATION:
Pull the carburetor to a point where the groove [1] of
the throttle arm lines up with the governor rod [2],
and then lift the governor rod out of the hole of the
throttle arm and unhook the throttle return spring [3].
[2]
[3]
TUBE CLIP
CARBURETOR
[1]
TUBE
CLAMP
INSTALLATION:
Before installing, clean the passage [1] thoroughly
with compressed air.
Install the carburetor insulator with the vent groove
facing toward the carburetor.
After installing, clamp the high-tension cord [2], the
engine wire harness [3] and fuel tube [4] to the
carburetor insulator.
[4]
[2]
[1]
[3]
Summary of Contents for FQ650
