Honda EU70is, Owner'S Manual

Page: 58 / 380

55
SERVICING YOUR GENERATOR
ENGINE OIL CHANGE
Drain the oil while the engine is warm to assure rapid and complete
draining.
1.Open the right maintenance cover by turning its latch

counterclockwise.
2.Reach under the generator and remove the black rubber seal located
below the oil drain plug.
3.Place a suitable container underneath the generator to catch the used
oil.
4.Remove the oil filler cap.
5.Remove the oil drain plug and sealing washer and allow the oil to
drain completely.
6.Reinstall the oil drain plug and a new sealing washer. Tighten the
plug securely.
7.Reach under the generator and reinstall the black rubber seal.
Improper disposal of engine oil can be harmful to the environment.

If you change your own oil, please dispose of the used oil properly.
Put it in a sealed container, and take it to a recycling center. Do not
discard it in a trash bin, dump it on the ground, or pour it down the
drain.
8.With the generator in a level position, fill with the recommended oil
(see page 56) to the upper limit of the oil filler neck.
Maximum oil capacity: 1.1 L (1.16 US qt, 0.97 Imp qt)
9.Reinstall the oil filler cap securely.
10.Close the right maintenance cover by turning its latch clockwise.
Wash your hands with soap and water after handling used oil.
BLACK RUBBER SEAL
SEALING WASHER
(Replace)
OIL FILLER CAP
OIL FILLER
CAP
OIL DRAIN PLUG
UPPER
LIMIT
36Z376000.book 55 ページ ２０１４年９月１９日 金曜日 午後６時２６分