© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
AII 32445 (0605)
13 of 24
40. Position template A on the center console at the
location shown, and attach template A to the
center console using strips of tape.
41. Using a push-pin, mark the center console at the
marks on the template. Remove the template.
42. To the prevent drilling through the inner panel,
wrap tape around the end of a 3 mm and an 8 mm
drill bit about 15-20 mm away from the tip.
4915060H
PUSH-PIN
TEMPLATE A
CENTER
CONSOLE
TAPE
43. While wearing eye protection, drill an 8 mm hole at
each marked point. Start with a 3 mm drill bit and
finish with an 8 mm drill bit. Remove any burrs
from each hole.
4915070H
MARK
CENTER
CONSOLE
DRILL
DRILL BIT
(3 mm 8
mm)
TAPE
(Wrap tape around
the drill bit)
DRILL BIT
38. Route the
i
-VES harness, DIN cable “A” and DIN
cable “B” toward the rear of the vehicle.
39. Slide the center console cup holder forward, and
slide the inner cover forward. Open the console
cover.
4915044H
i
-VES
HARNESS
VEHICLE
FRAME
DIN
CABLE “B”
DIN
CABLE “A”
4915050H
CENTER
CONSOLE
CUP
HOLDER
INNER
COVER
CONSOLE
COVER
15-20 mm
