© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
AII 32445 (0605)
11 of 24
31. Route the DIN cable “A” between the headliner and
insulator, from the passenger's A-pillar to the
opening in the headliner you made step 30.
32. Route the yellow label side of DIN cable “A” along
the vehicle harness, and temporarily secure DIN
cable “A” to the vehicle harness with one wire tie.
33. Using isopropyl alcohol on a shop towel, clean the
area where the EPT sealer will attach. Using
scissors, cut one EPT sealer in half. Wrap one
half EPT sealer to DIN cable “A” in the area
shown.
29. Using a felt-tip pen, mark the headliner along the
outer edges of the template. Remove the template
and add the lines to the mark you made on the
headliner in the positions shown.
30. Using a utility knife, cut out the marked area of
the headliner, and cut out the insulator from the
vehicle frame.
4913072H
FRONT
FELT-TIP
PEN
HEADLINER
TEMPLATE
HEADLINER
FELT-TIP
PEN
Add the lines
to the mark.
4913082H
FRONT
MARK
HEADLINER
(Cut out
this area.)
UTILITY
KNIFE
INSULATOR
(Cut out.)
4913113H
250 mm
DIN
CABLE “A”
HEADLINER
OPENING
FRONT
YELLOW
LABEL
DIN CABLE “A”
TERMINAL
4915014H
DIN
CABLE “A”
EPT SEALER
Cut in half.
YELLOW
LABEL
350 mm
VEHICLE
HARNESS
WIRE TIE
(Loosely fasten)
VEHICLE
CLIP
