© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
AII 30200 (0508)
7 of 13
16. Position the side brackets on the CD changer and
install the four 4 x 8 mm washer-screws included
in the attachment kit.
17. Remove the adhesive backings from the CD
changer cushions A and B, and attach them to
both sides of the CD changer.
19. Using a tape measure and a felt-tip pen, measure
and mark the center console box inner cover as
shown.
2221071K
CD CHANGER
CUSHION A
CD
CHANGER
CD CHANGER
CUSHION B
TAPE ATTACHING FACE
(Align with the lines on
the CD changer.)
CUSHION
TAPE
(Cut in
half.)
CD
CHANGER
BRACKET B
CD CHANGER
CUSHION B
CD CHANGER
2221050K
CENTER CONSOLE
BOX INNER COVER
Remove the
marked areas
with a file.
5 mm
5 mm
20. While wearing eye protection, drill a 10 mm hole at
the marked location. First drill with a 3 mm drill bit,
and finish with a 10 mm drill bit. After drilling,
remove any burrs, and any material from the hole
using a round file.
21. Locate the four marks on the front and rear of the
center console box. While wearing eye protection,
drill with a 3 mm bit, and finish with a 7 mm bit
through each marked location. After drilling,
remove any burrs from the edges of the holes with
a round file.
2221060K
4 x 8 mm
WASHER-
SCREW
CD CHANGER
BRACKET B
CD CHANGER
4 x 8 mm
WASHER-
SCREW
CD CHANGER
BRACKET A
18. Using scissors, cut the cushion tape in half.
Attach the two cushion tapes to the CD changer in
the areas shown.
2221080K
CENTER
CONSOLE
BOX
DRILL BIT
(Drill first with a 3 mm
drill bit, then finish
with a 7 mm drill bit.)
DRILL
FRONT
DRILL BIT
(Drill first with
a 3 mm drill
bit, then finish
with a 7 mm
drill bit.)
DRILL
REAR
CENTER
CONSOLE
BOX
