2 of 13
AII 30200(0508)
© 2005 American Honda Motor Co., Inc. - All Rights Reserved.
TOOLS AND SUPPLIES REQUIRED
Phillips screwdriver
Flat-tip screwdriver
Small flat-tip screwdriver
10 mm Combination wrench
Drill
3 mm, 7 mm, and 10 mm Drill bits
Round file
Isopropyl alcohol
Shop towel
Masking tape
Hook tool
Tape measure
Eye protection (face shield, safety goggles, etc.)
Scissors
Illustration of the CD Changer installed in the
Vehicle
INSTALLATION
Customer Information: The information in this
installation instruction is intended for use only by
skilled technicians who have the proper tools,
equipment, and training to correctly and safely add
equipment to your vehicle. These procedures should
not be attempted by “do-it-yourselfers.”
1.
Make sure you have the anti-theft code for the
radio, then write down the radio station presets.
2.
Disconnect the negative cable from the battery.
3.
Remove the trim ring.
M/T Model:
•
Squeeze the plastic clip and pull down on the
shift boot. Remove the shift knob by turning it
counterclockwise.
2226030K
CD CHANGER
BUS CABLE
•
Gently pry up on the trim ring to release the six
clips.
2321011K
SHIFT
KNOB
PLASTIC
CLIP
SHIFT
BOOT
TRIM RING
2321021K
CLIPS (2)
TRIM RING
CLIPS (4)
