page 2 of 16
ALFA IN a.s. ©
www.alfain.eu
1. INTRODUCTION
Congratulations on your new ALFA IN product. We are proud to have you as
our customer and will strive to provide you with the best service and reliability
in the industry.
This Operating Manual has been designed to instruct you on the correct use
and operation of your ALFA IN product. Your satisfaction with this product
and its safe operation is our ultimate concern. Therefore please take the time
to read the entire manual, especially the Safety Precautions. They will help
you to avoid potential hazards that may exist when working with this product.
Read and understand this entire Manual and your employer’s safety
practices before installing, operating, or servicing the equipment. While the
information contained in this Manual represents the Manufacturer's best
judgement, the Manufacturer assumes no liability for its use.
Welding machine HOMER MG-150 of our private brand HOMER tools is
aimed for MIG/MAG welding.
The machine can weld various types of joints (butt, single-sided, double-
sided, fillet, lap, etc.) using wire diameter from 0.6 to 0.8 mm, respectively.
1.0 mm (flux cored wire) of different metals and alloys (carbon and alloy
steels, aluminium alloys, etc.). HOMER MG-150 is especially designed for
bodywork operations or maintenance work. Very good welding can be
achieved under a protective atmosphere of CO2. The machine welds very
well by means of using high-quality self-shielding wire (no gas cylinder and
pressure reducer needed).
2. SAFETY INSTRUCTIONS AND WARNINGS
OPERATION AND MAINTENANCE OF WELDING EQUIPMENT CAN
BE DANGEROUS AND HAZARDOUS TO YOURHEALTH.
Arc welding produces intense electric and magnetic emissions that may
interfere with the proper function of cardiac pacemakers, hearing aids, or
other electronic health equipment. Persons who work near arc welding
applications should consult their medical health professional and the
manufacturer of the health equipment to determine whether a hazard
exists.
Once the packing has been opened, make sure that the machine is not
damaged. If in any doubt, call the service centre.
This equipment must only be used by qualified personnel.
During installation, any electric work must only be carried out by trained
personnel.
The machine must be used in a dry place with good ventilation.
