12
NOTE: The transmitter(s) supplied with your
opener are preprogrammed by the factory.
If you purchase additional transmitters, the garage
door opener must be programmed to accept the new
remote code.
Program the Receiver to Match Additional
Transmitter Codes:
Using the “S” SAVE Button
1.Press and Hold the button on the hand-held remote
that you wish to use (1).
2.Press and release the “S” button on the opener (2).
3.Release the remote button when the courtesy light
flashes twice. It has learnt the code. If you release
the remote control push button before the opener
light flashes, the opener has not learnt the code.
Now the opener will operate when the remote control push button is
pressed.
To Erase all Remote Control Codes
1.Press and Hold the “S” button on the opener until the courtesy light
flashes twice, and continue holding for approx. 8 seconds, until the
courtesy light flashes twice again.
2.Release the button, all codes are now erased.
Activate the opener only when door is in full view, free of obstruction and properly adjusted.
No one should enter or leave garage while door is in motion. Do not allow children to operate
push button(s) or remote(s). Do not allow children to play near the door.
N2966
N2966
N2966
N2966
1
2
Flash x 2
BEEP
DN
DN
UP
UP
P
P
S
S
1
1
2
2
3
3
19
WIRELESS PROGRAMMING (OPTIONAL ACCESSORIES)
