![background image](http://html.mh-extra.com/html/homenetwerks/smartvent-7146-80-ms/smartvent-7146-80-ms_manual_2153909009.webp)
9
HomewerksWW.com
EXISTING CONSTRUCTION INSTALLATION INSTRUCTIONS
5. Slide the grille mounting brackets to the left and remove them
from the fan housing (A).
Remove the three prong fan plug from the fan housing (A) and
pull the black fan motor straight out of the metal fan housing (A).
A
Mounting
brackets
Fan
motor
Fan
plug
5
6. Remove the wiring cover. Pull the house wires through the
wiring cover hole. Using the attached quick connectors,
connect 120v house wiring to the fan as shown in the wiring
diagram on page 5. 12-18 AWG is the smallest conductor that
should be used for branch circuit wiring.
Carefully push the connected wires back into the wiring box
housing. Reattach the wiring box cover.
CAUTION:
If the house electrical wires do not match the
colors from the fan wiring diagram on page 5, you must
determine what each house wire represents before
connecting. You may need to consult an electrical
contractor to determine safely.
6
Wiring
cover
Wiring
cover
House
wires
Quick
connector
Product
wires
7. Connect a 4 in. circular duct (not included) and vent to the
outside. Secure it with duct tape (not included) or a clamp
(not included) to make the connection secure and airtight.
Finish ceiling work. Ceiling hole should be aligned with edge
of the fan housing (A).
7
A
8. Insert the fan housing (A) into the ceiling hole. Mount the
housing (A) to the ceiling joist with three wood screws
through the holes in the side of the fan housing (A).
The fan housing (A) must be installed flush with ceiling board
or drywall in order for the grille mounting springs to be long
enough to insert into the slots in the fan housing (A).
Hardware Used
AA
Wood screws
x 3
A
AA
8