40
Start-up
The network terminals may be used only for con-
necting the power supply to the device or for
connecting loads to the device. The connection
(looping through) of conductors via the network
terminals of the device to other devices is not
permitted!
• Connect the bus using the supplied connecting
cable (
see figure 4
).
For electrical safety reasons, only the supplied
Homematic IP Wired Bus Cable may be used for
connecting the device to the Homematic IP Wired
bus. Furthermore, an eQ-3 Homematic IP Wired
Bus Cable with other lengths (available as
accessory) can be used.
The bus connections
(E)
and
(F)
are switched in
parallel. However, the incoming or outgoing bus
cable can be connected to any of the two
connections.
• Use the supplied bus blind plug, if bus connection
1
(E)
or bus connection 2
(F)
are not needed.
• Reattach the cover of the distribution board.
• Switch the fuse of the power circuit on again to
activate the teach-in mode of the device (see “5.4
Teaching-in” on page 41).
