HomeMatic HmIP-SRD, Mounting Instruction And Operating Manual

Page: 40 / 53

40
Start-up
• Lead the supply cable through the opening of the
cable gland so that the nut can be screwed on
again afterwards.
• Extend the first 15 cm of the cable and tighten the
nut below 15 cm on the cable gland ( see figure
5+6 ).
• Lead the cable with the cable gland through the
housing opening provided for it ( see figure 7 ).
• Lead the locknut over the end of the cable and
screw it onto the cable gland ( see figure 8 ).
To tighten or loosen the nut, you can optionally
use an open-end wrench (see
figure 9 ).
• Connect the cable to the connecting terminals
on the housing cover ( see figure 8 ).
To connect or loosen the conductor, the white
actuation lever at the top of the clamp has to be
pressed.
• Place the housing cover back on and close the
device using the screws.
• Provide power supply for the device using the
power supply unit.