HomeMatic HmIP-SRD, Mounting Instruction And Operating Manual

Page: 43 / 53

43
Start-up
The device must be mounted so that it is
protected from mechanical loads and the effects
of vibrations.
Select an installation site at which you can access
the device for maintenance.
When selecting the installation location, check
for electrical wires and power supply cables.
Do operate the device only when its closed.
There are two break-out openings at the back
side of the device for opening drainage holes. If
required, they can be fully opened using a pointed
object. Any burr resulting from that has to be
removed. The device should be mounted in a 45
degree angle so that moisture can drain through
the break-out openings and the unit is not
damaged by incoming moisture.
The mounting location should be constructed in
that way that the rain sensor can be installed in a
45 degree angle. For even surfaces (such as a
house wall) the 45 degree bracket
(F) can be
used. For surfaces that are already at the correct
angle, the 0 degree bracket
(G) can be used.