64
- If the smoke detector has to be surface-
mounted, use the spacers supplied to mount
the smoke detector such that the cable can be
routed into the device without being pinched.
- Feed the cable through the opening on the base
and use a cable tie to fix the required length in
place on the retainer on the base. Make sure
that you leave a sufficient length of cable so that
the batteries can be easily replaced at a later
time.
- Strip around 6 mm at the ends of the cable.
- Pull the cable terminal off and insert the
stripped cable ends into the terminals. Observe
the correct polarity as per the sketch and in
accordance with the stamp inside the housing in
front of the cable terminal.
- Reinsert the cable terminal and check again that
the cabling has the correct polarity.
- Attach the smoke detector to the base. In doing
so, make sure that the cable is not pinched by
the neoprene seal when the smoke detector is
attached to the base. Any surplus cable can be
housed in the module receptacle in front of the
cable terminal. Please note that an excessive
amount of cable above the module cover can
impair wireless transmission.
Summary of Contents for HM-Sec-SD
Page 37: ...37 ...
