8
In addition, we would suggest you consider the following
for your massage chair location:
• Choose a low traffic area so you can create a peaceful
environment when getting your massage.
• Choose a location in your home that makes you feel the
most comfortable and relaxed, but is also convenient.
• Adjustable lighting near the chair allows you to create
the right setting for your mood.
Moving Your Chair
Once you have selected the location for your chair, you
can easily move it with the convenient wheels located
on the rear of the chair (Fig. 7).
To move your chair, stand behind the chair and tilt it back-
wards until the wheels are engaged. Then simply push your
chair to the location you want. When you are lowering the
front of the chair in the spot you want it, be careful not to drop
it too hard or fast, as it may cause damage to your floors.
Turning On Your Chair
The eLounger massage chair has a master power switch
that must be in the “on” position in order to work. Once you
have plugged the chair power cord into the electrical outlet,
turn on the master power switch located on the back of the
chair (Fig. 8). Within the control panel, the green “e” in
eLounger and the red LED below it will illuminate to confirm
that the chair has power.
Reclining Your Chair
You can adjust the backrest angle to recline up to approxi-
mately 160 degrees. Reclining the backrest increases the
intensity of the massage, and also repositions the body so
that the massage range along your back and neck is
changed. Typically, the further you recline, the further the
massage will reach in the shoulder and neck area.
Recline
To recline the backrest using the manual control, lift the lever
on the right side of the chair seat (Fig. 3) and lean back.
When you are in the desired position, release the lever.
When you are ready to raise the backrest, pull the lever up
again and lean forward. The hydraulic gas system will raise
the backrest for you.
NOTE
: In order to avoid strain and potential injury to your
back, never attempt to get in or out of the massage chair
with the backrest reclined.
Adjusting the Cushions
There are two adjustable cushions that are included with
your chair: the backrest softening pad and the lumbar/
headrest pillow.
THE BACKREST SOFTENING PAD
Your massage chair comes with a backrest softening pad.
It is recommended that you have this softening pad installed
for the most comfort while just sitting in the chair. In addition,
it is recommended that you use the softening pad while
getting a massage until your body is “used to” the intensity
of the massage. Once you are comfortable with it, you may
want to increase the intensity of the massage by removing
the softening pad. This will allow you to experience a deeper,
massage.
To install the softening pad:
• Lift the flap at the top of the chair to expose the ends of
the zippers (Fig 9) and unzip each side.
• Locate the inside pocket that holds the softening pad
(Fig.10). Simply insert or remove the softening pad (Fig. 11)
from this pocket.
• Close the zippers and the top flap.
THE LUMBAR/HEADREST PAD
The lumbar/headrest pillow (see page 16) is provided for
customized comfort. You may adjust its location to fit your
needs. For example, you can support your head and neck
or your lumbar area.
ADDITIONAL CUSHIONS:
You may add additional cushioning to the chair with your
own pillows. Keep in mind that the more cushioning you
add, the less you will be able to feel the massage.
Cup Holder
As an added convenience feature, the eLounger includes a
cup holder in the right armrest that will hold many types of
containers. To help maintain cleanliness, there is a removable
insert. A soft, damp cloth is recommended for cleaning.
Please see page 17 for additional information on care and
use for the eLounger.
9
Figure 11
Figure 7
Figure 8
Figure 9
Figure 10
