- 12 -
4B.4)
With the help of another person,
lift the fire box(A) and hang up the
fire box onto the wall with the
screw(BB).
Note:
Do not fasten the screws tightly.
Leave 1/4” (6mm) spacing.
4B.5~10) The subsequent steps are Flush Mounted Installation same,
Refer to step 4A.6~4A.11 of page 8~10.
Electrical Connection
WARNING:
Do not attempt to wire your own new outlets or circuits. To reduce the risk of
fire,electric shock or injury to persons, the hard wiring must be supplied with a qualified
electrician.
WARNING:
Ensure that the circuit on which the fireplace is to be installed has the power cut
off at the service panel until installation is complete.
The fireplace is packaged with a three prong plug installed for plug-in convenience. Hard
wiring the fireplace is also an option for any installation.
a. Plug in (the power cord is 6ft(1.8m) long and on the right of the fireplace, you may run
the power cord out of the framed wall opening to an existing outlet or install an outlet on a
nearby wall stud within the wall). If the cord is not long enough to reach the outlet, a
rounded extension cord minimum AWG No. 14 wiring and rated to a minimum or 1875 watts
may be used.
b. Hard wire the fireplace (recommended). A qualified electrician may remove the cord
connection,and wire the appliance directly to the house hold wiring. The appliance must be
electrically connected and grounded in accordance with local codes.
Summary of Contents for ZHX-36-027
Page 2: ......
