Holzmann ED 750 FD, User Manual

Page: 32 / 64

ASSEM BLY
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Seit e 3 2
METALLDREHMASCHINE / METAL TURNING LATHE ED 750FD
1 3 ASSEM BLY
1 3 .1 Scope of delivery
The ED 750FD is delivered fully assembled in principle.
In addition, the tool is included in the case.
1 3 .2 Preparat ory act ivit ies
13.2.1 The w ork place
Choose a suitable place for the machine.
The workplace must:

have sufficient lighting.

a straight, flat, floor exhibit

with minimal vibration values (such as concrete).

The machine should be mounted on a solid work surface which also flat, straight and vibration
(eg massive workbench)

Allow sufficient space around the machine

Provide a suitable freely accessible supply 230V / 50Hz and sufficient backup.
Observe the safety requirements of Chapter
1 2
as well as the dimensions of the machine.
You also need a minimum distance of
0 .5
m around the machine completely secure to ensure
safe working.
13.2.2 Transport / unloading t he m achine
W A R N I N G
The lifting and transport of the machine must be performed by qualified per-
sonnel
Also make sure that the location can support the weight of the machine.
1 3 .3 Assem bly
13.3.1 Cleaning
Remove the anti-corrosion protection and grease before putting the machine through kerosene
(paraffin) or turpentine of all tours and the transmission. Do not use thinner or other strong sol-
vents. Lubricate all the bright faces of the machine directly after its cleaning. Do not use heavy oil
or grease for the gearbox.
13.3.2 I nst alla t ion
Place the lathe on a solid surface.
A
concrete floor is the best foundation for the machine, if ne-
cessary, use a base. Make sure that you have enough space around the machine to optimally op-
erate and maintain. Adjust the guides exactly a bed, then tighten the foundation bolts evenly and
finally check the stand.