STORAGE
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
33
ZX40PC
18.2.1
Exchange gear box oil
N O T E
Lubricants and coolants are toxic and must not be released into the
environment. Be careful when handling and do not spill anything! Follow
the manufacturer's instructions and, if necessary, contact your local
authority for information on proper disposal.
To drain the gear oil, loosen the screw (1).
(Located on the underside of the gear head).
Set up oil tray see note to properly catch oil.
After gear oil has been completely drained. Close drain plug
(1) again and fill with new gear oil.
18.2.2
Adjusting guidance clearance (X,Y-axis)
The guidance clearance can be adjusted (as
shown) for the corresponding axis (x,y)
18.2.3
Inspection and Maintenance Plan
The type and degree of machine wear depends to a large extent on the operating conditions. The
following intervals apply when the machine is used within the specified limits:
Interval
Component
Activity
Before usage
Gear box oil level
check and refill if necessary
Cable and plug
Check for damage and replace if necessary
coolant
check and refill if necessary
weekly
Screw connections
check for tightness
Moving parts
lubricate
spindle
lubricate with gear grease
monthly
coolant
Replace completely; clean coolant tank with
pressurized water jet before refilling.
Half a year
Gear box oil
Exchange gear box oil
annually
Cross table
check parallelism
STORAGE
N O T E
Improper storage can damage and destroy important components. Only store packed
or unpacked parts under the intended ambient conditions!
In case of a prolonged interruption of operation or shutdown, clean the machine, empty the
coolant container by draining the coolant into a collection container and then store the machine
out of the reach of children in a dry place protected from frost and other weather influences!
