OPERATION
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
28
ZX40PC
5.
Mounting/removing drill and morse-
taper adapter
Degrease all parts.
Use a rubber hammer to fix the drill or
taper adapter with a careful punch.
To remove the drill/adapter again,
extend the spindle and turn it until you
can attach the drift wedge. Remove
drill/adapter with a careful punch.
16.4
Aligning the Machine
Using a precision balance, align the machine so that the
deviation in the longitudinal and transverse directions is
less than 0.04 mm/1000 mm. If is recommended to
use vibration dampers.
OPERATION
17.1
Operating instructions
17.1.1
Points to be obsorved
Before starting to work
After work have finished
Lubricate all lubrication points
Disconnect the machine from the power
supply.
Remove unused tools / parts
Remove tools from the machine
Make sure that the vice and the workpiece are
properly fastened.
Clean and lubricate the machine.
Check that the spindle speed has been
selected correctly and that the maximum
drilling/milling diameter is within the technical
limits.
Cover the bare surfaces on the machien with a
corrosion protection agent to avoid corrosion.
Make sure that there are no chips on the
sliding surfaces.
17.1.2
Checking the screw connections
Before each start-up, check all screw connections and tighten them if necessary.
17.1.3
Filling with lubricant and coolant
N O T E
Lubricants and coolants are toxic and must not be released into the
environment. Be careful when handling and do not spill anything! Follow
the manufacturer's instructions and, if necessary, contact your local
authority for information on proper disposal.
Supply all relevant locations with gear oil VG220 (recommended for ISO 12925-1 CKD,
DIN51517 Part 3 CLP, US Steel 224, AGMA 9005-E02).
Fill the cooling system with adequate and sufficient coolant (e.g. type KSM5L).
