HOLZMANN MASCHINEN KF 200L, User Manual

Page: 35 / 56

OPERATION
HOLZMANN Maschinen Austria www.holzmann-maschinen.at Seite 35
Kreissäge – Fräse / circular saw – spindle shaper combination KF 200L
15.4 Milling
Before starting to working check the saw – cutter!
(Selctor switch (A) is only optional to operate with an attached planer)
-
Turn the selector knob (B) to the right on molling
Push the EMERGENCY STOP switch (C) in direction of the
arrow and release
- Start with button “ I “ –green- to start the machine
- Stopp with red button “ O “ –red- to stop the machine
EMERGENCY STOP switch
Pressing the EMERGENCY STOP switch (C) the machine stops
immediately.
15.4.1 Changing the milling head
 Switch off the machine
 Secure the end cap with a 22mm Allen key
Use an Allen wrench to remove the screw from the spindle 8mm
remove.
 Remove the cutting head and replace these by the appropriate.
 Set a distance from the table top from at least 2mm clearance.
 Install the milling tools as low as possible.
 Select to match the height of the milling tool, so that it at least
2mm
 is over the spindle top. Insert the end cap.
 Now screw in the allen screw and tighten it firmly on the spindle.
1. Mount spindle shapper protection as in 14.2.2
2. Spindle height as set in 15.4.2
Check immediately after mounting the free run of the mill.
NOTES
- Beware material setback! To minimize the danger of material setback, they put the hold-
down on Workpiece max. 2mm one.
- Set spindle shapper protection on the workpiece width + max 5mm one.
B
A
C