CLEANING, MAINTENANCE, STORAGE, DISPOSAL
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
24
HUB15FLEX_24V; HUB15MOVE_24V
17.2
Maintenance
W A R N I N G
Danger due to electrical voltage! Always disconnect the machine from the power
supply befor servicing or maintenance work and secure it against accidentally re-
activation!
The machine is low maintenance and only a few parts require mainencance.
Malfunctions or
defects that are likely to impair your safety must be rectified immediately!
• Check that the safety devices are in good condition before each operation.
• Check the connections at least once a week for a tight fit.
• Check the correct and readable status of the Machine's warning and safety labels on a
regular basis.
17.2.1
Maintenanceplan
Wear of machine depends strongly on operation condition. The following intervals are valid when
using the machine within the operation limits
Interval
Component
Activity
Daily
Charging status of
battery
Check status of battery indicator and charge if
necessary (<30% red light).
hydr. Lifting system
Lift the forks to highest to check the hydraulic oil is
adequate. Add hydraulic oil N32 or similar oil if
needed
Weekly
wheel
Check wheels and clean
Half-yearly
motor
Check brush war in the motor, replace undesirable
brush
battery
Charge battery after long storage
Annually or
after 200h
hydraulic oil
Replace hydraulic oil N32 or similar
After 200h operation, the LED flashes red, green and blue. After performing maintenance, this
condition can be reset. Procedure is: Press the Emergency reverse button and the direction lever
in one direction at the same time.
17.3
Storage
N O T I C E
If stored incorrectly, important components can be damaged and destroyed. Store
packaged or already unpacked parts only under the intended environmental
conditions.
Store the machine only in a dry environment protected from weather conditions.
If the machine is scheduled to stop for a long time, make sure that the battery is approximately
2/3 charged. A reloading is then necessary after 6 months.
17.4
Disposal
Observe national waste disposal regulations. Do not dispose of the machine,
machine components or operating materials in residual waste. If necessary,
contact your local authorities for information on available disposal options.
If you buy a new machine or an equivalent machine from your retailer, he is
obliged in certain countries to dispose of your old machine properly.
Summary of Contents for HUB15FLEX 24V
Page 33: ......
