ASSEMBLY
HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at
Seite 35
METALLDREHMASCHINE / METAL TURNING LATHE ED 1000G / GDIG
12.4.5
Other parts
Additional lubrication points can be found on the drive shaft, the hand wheels to the lock case
and the tailstock. Lubricate them regularly with a grease gun.
Apply a thin coat of oil on the machine bed and all other exposed parts like on the tailstock,
screw cutting, etc. once a day.
12.4.6
Retraction prior to initial
The retraction should be performed with the lowest screw speed. Let the machine at this speed
for about 1 hours walk. Check out irregularities, such as unusual noises, imbalances, etc. If
everything is ok, you gradually increase the speed. The highest speeds may be driven only
after 10 hours of operation.
12.4.7
Leveling tailstock to headstock
Tighten properly between spindle and tailstock up a 305mm long solid piece of pipe.
Cock now in the tool holder has a digital Display one.
Run with manual feed (handwheel) the top slides along the workpiece. When measuring differ-
ences of tailstock is adjusted using the adjustment screw on headstock with tailstock (see fig-
ure) until no more measuring differences exist.
Summary of Contents for ED 1000G
Page 89: ......
