holzkraft 5966770, Translation From The Original Instruction Manual, Page: 29 / 56

page: 29
GB
• Keep machine clean.
• Wear protective goggles when cleaning.
Before undertaking any maintenance or checking work, the working area must be cleaned. Keep the necessary tools within the
reach of your hand.
The intervals mentioned herein are based on normal conditions of use. An excessive use of the machine shortens the intervals ac-
cordingly.
Clean the panels, screens and control levers with a soft cloth. The cloth should be dry or slightly humid with a neutral cleaning agent.
Do not use any solvents like alcohol or benzene as they could damage the surfaces.
Keep oils and lubricants out of reach of unauthorised persons. Read through the instructions on the containers carefully and follow
them closely. Avoid direct contact with the skin and wash off thoroughly after use.
Check the V-belt tension after the first hour of operation and every time before starting up. To do so, undo the T-screw on the motor
bracket. Press the bracket down and tighten the T-screw again.
All ball bearings are lifetime lubricated. The circular saw blade is a wearing part and must be checked every time before starting up.
Only a well-sharpened, correctly set saw blade delivers good cutting results. Occasional greasing of the saw blade is recommended.
If signs of wear appear in the swivel saw slit, the swivel parts must be replaced. .
Additional maintenance work with Cardan shaft operation
Fig.5
Tightening the V-belt (Fig. 5)
• Undo the hexagonal screws and press the gear unit down
evenly. The gear unit must be adjusted parallel.
• Tighten hexagon screws firmly.
Fig.6
Replacing the transmission oil (Fig. 6)
• Replace the transmission oil annually.
• Use SAE 90 transmission oil.
• The capacity is 0.35 litres.
• Figure 6 shows the angular transmission oil filler plug.
• Dispose of used oil in an environmentally friendly manner.
m
Check all safety devices after maintenance and cleaning work.
Attention! Check the V-belt tension after the first hour of
operation and before each start-up.