Holtkamp Electronics DUO 8600XL techn. stand 05.2016 4033_05.2016 V01.2021
- 11 -
12.2 Basic programming for operating mode
“Timer” (factory setting)
Your DUO has been factory set with standard programming. The
program values are written in the appropriate displays.
12.2.1 Time/price menu, cash = card “no”
to call with:
to quit with:
Is non-existing a chip card type 53, you can start the menu also
with change over the DIP switches no. 1 and 3 on "on".
If the programming is finished, you must change only DIP
switch no. 1 on "off".
insert chip card
type 53
pull out chip card
type 53
Following menu options are successively programmable:
The grey deposited menu options must be only activated in
the configuration menu with payment type, otherwise they
do not appear by programming.
Display ad
Factory setting
Description
Brightness
100%
The brightness is used for the illumination of the display. The brightness is ad
-
justable in steps of 2%, from 0% to 100%.
Pre-run time
2.00 min
The lead time is the time difference between payment at the coin or chip card
timer and the start of the connecting device. It can be adjusted in steps of 5
seconds, to a max of 9 min 55 sec. The pre-run count-down can be prematurely
interrupted by the
remote start
.
The remote start gives the possibility to activate by an external button. 2 proce
-
dures are possible. In the first case the lead time is set on lower than “0”. In this
case the lead time was ended by pressing the remote start and the main-time
starts immediately. In the second case the lead time is set on = “0”. In this case
begins the main-time, first, after activating the remote start. This can be called
as a forced remote start. Should a connected customer be operated without
delay and activating the remote start, the jumper FS must be activated on “0”
(see picture of electronic, chap. 1.2.).
The remote start has to be carried out, basically, potential free to the ex-
ternal tester on the tanning bed.
Main time 1
0:02:00 min
The main time 1 is the operating time of connected device which can be bought
with coins or a chip card. It is recallable and programmable if any adjustments
have been made in the configuration menu. (cash = card). It can be adjusted in
1 second steps, to max. of 99:00 or 1 hr 39 min. If in the configuration modus
the menu point ”
3 digits main time
” is set on “
yes
”, the main time can be ad
-
justed up to 255 min in seconds steps.
Main time 2
0:03:00 min
The main time 2 is the operating time of the connected device, payable by coins
or by chip card. It is always active on the second step of the various payment
types. It is recallable and programmable if any adjustments have been in the
“
Configuration menu“
. It can be adjusted in 1 second steps, to a max. of 99:00
min or 1 hr 39 min. (see main time 1)
Main time 3
0:04:00 min
Main time 3 analogue main time 2
Main time
card 1
0:02:00 min
Main time card 1 is operating time of the connected device, payable by chip
card. It is recallable and programmable if any adjustments have been made in
the “
Configuration menu
“. It can be adjusted in 1 second steps, to a max. of
99 min or 1 hr 39 min.
