Holmatro 200.401.001, Manual

Page: 20 / 148

EN
20 917.219.005_005 JJ/PL
All pictograms attached to the equipment pertaining to safety and danger must be complied with and
remain clearly legible.
/i
2.3 General safety regulations
• Use this equipment solely for the activities for which it was designed. If you are in doubt or
uncertain, always consult your Holmatro dealer.
• Replace illegible safety symbols, pictograms and information labels with identical ones, available
from your Holmatro dealer.
• Varnished, plastic and rubber parts are not resistant to corrosive acid or liquid. Except for electrical
parts, rinse parts that have come into contact with corrosive acid or liquid with a lot of water. Consult
your Holmatro dealer for a resistance list.
• Prevent dirt in and on the couplers.
• Protect equipment against sparks during welding or grinding activities.
• Avoid an unhealthy posture while working. It can result in physical complaints.
• Follow the inspection and maintenance instructions.
• Conversion of the piece of equipment or the system may only be performed by a Holmatro Certified
Technician. In case of a conversion, retain the original manual and the conversion manual.
• Use only genuine Holmatro parts and maintenance products prescribed by Holmatro.
2.4 Personal safety
Personnel that uses or assists in the use of the equipment must wear all personal means of protection
as prescribed in the standard work procedure. Negligent use of personal means of protection can result
in serious injury. During use wear at least the following personal means of protection:
•
Helmet;
• Safety goggles or full face shield;
WARNING
Not following these instructions can result in serious personal injury, fatal accident, damage
to the system or consequential loss.
Type of mark Position Description Part number
Instruction A • Read the user manual before use.
• Wear a helmet with safety goggles/face shield.
• Wear protective clothing that covers the entire body.
• Wear safety gloves.
• Wear safety shoes.
Banner B Do not use the jack beyond it’s rated capacity..
C Do not use the jack horizontal or top-side-down
D Always centre the load and use the whole saddle to
support the load.
E Do not use extension pipes between the load and
saddle. Make sure the load is parallel to the saddle..
F Never work under or between the load
Model plate G Manufacturer’s information stating: name, address, CE
marking, model indication, serial number and date of
construction, maximum operating pressure.
Caution H Weight exceeding 25 kg.
Model plate I CE marking