THERMO
HYGRO
SENSOR
Starting at the top, insert the ‘U Shaped’ plastic bracket (labelled 1) into the top of the stainless
steel pole & fix with a bolt & nut.
Slide plastic bracket (labelled 2) with the Rain gauge onto the pole from the bottom and secure
with a bolt and nut.
Slide the remaining plastic bracket (labelled 3 with nothing attached so far) onto the pole from the
bottom and secure with a bolt & nut.
Orientate the brackets 2 & 3 to ensure the Rain Gauge is away from the Wind Sensors and is in
‘clear air’. Likewise the Thermo Hygro Sensor (once attached) will need to be in ‘clear air’.
Once orientation is good, make sure all the bolts and nuts are secure.
Assembling The Sensor Unit
5
5) Mount the Thermo Hygro Sensor to the plastic bracket
(labelled
‘3’ in illustration opposite)
4) Mount the plastic brackets onto the stainless steel mast
(Please refer to illustration opposite)
Insert the cables from the Wind Sensor & the Rain Gauge into the correct sockets. These are
labelled on the plastic under the sockets.
Next, install the batteries - (refer to Page 6)
Then fit the Thermo Hygro Sensor to the plastic bracket (labelled 3)
and fix with a bolt & nut.
Once secure, take the louvered housing part and slide it over the
Thermo Hygro Sensor. (There are 4 small guide marks inside
the louvered housing to help locate it properly)
