MG1-3
®
The Holland Grill “Companion” model requires very
little assembly. The unit is mostly complete right
out of the box. Items that require actual assembly
are the (4) legs and the front lid-lifting handle. The
regulator is installed per grill use and removed
when grill is not in use.
Tools needed for assembly:
1.
Phillips screwdriver
2.
3/8” nut driver
BEFORE BEGINNING ASSEMBLY
Select a clean flat surface, such as a table top. Open and empty
box. Remove drip pan and other loose components packaged
inside body. Check contents with list below to make sure no
parts are missing.
CONTENTS LIST
#
Description
1
GRILL BODY/LID ASSEMBLY
2
LEGS (4)
3
DRIP PAN
4
HANDLE BRACKET
5
HANDLE SPRING
6
COOKING GRID
7
REGULATOR
8
INSTRUCTIONS /DOCUMENTS
9
HARDWARE
10 GREASE PAN
11 DISPOSABLE GREASE PAN LINERS
12 CHIP TRAY
ASSEMBLY
1.
On a clean flat surface, such as a table top, select the
following parts for assembly:
1. body assembly
2. legs (4)
Also locate (16) each from the hardware pack
#10-24 x 3/8” phillips screws
#10 lockwashers
#10-24 hex nuts
Refer to figure 2. Install each of the legs with (4) screws, lock-
washers and locknuts as shown. LEAVE SCREWS LOOSE
UNTIL ALL LEGS ARE INSTALLED. With grill sitting on a flat
level surface, tighten screws.
2
. Refer to figure 3. Select the following
parts for assembly:
4. Handle bracket
5. Handle spring
Also locate (2) of each of the following from the
hardware pack:
#10-24 x 3/8” phillips screws
#10 lockwashers
#10-24 hex nuts
Open grill lid. Locate
handle bracket against
lid front as shown.
Install screws, lock-
washers and hex nuts
as shown. Tighten
screws. Install handle
spring onto bracket.
COMPANION GRILL ASSEMBLY INSTRUCTIONS
MODEL BH212 MG-1
11
10
9
7
6
5
4
3
2
1
figure 2.
figure 3.
8
12
Summary of Contents for BH-212-MG-1
Page 2: ......
