Hohner UNIVERSAL 43/6 S, Operating Instructions Manual

Page: 25 / 55

Operation
Hohner Maschinenbau GmbH HK 43/6 S 25
3.2 Feeding the stitching wire
- Fig. 9 -
- Shut off the wire transport (move triangular handle
g
until you see the feed wheels disengaged).
- Push the stitching wire through from above, as follows:
through the eyes
a
of the wire guide - between the two felt disks
b
through into the wire return
lock
c
- through the wire guidance tube
e
and between the two feed wheels
f
.
- Restart the wire transport (turn triangular handle
g
to the left).
- Mount adjusting handle
h
.
- Convey the wire to the knife by turning the adjusting handle
h
to the right.
3.3 Removing the stitching wire
- Shut off the wire transport (move triangular handle
g
until you see the feed wheels disengaged).
- Press adjusting disk d on wire return lock downwards, in order to eliminate its clamping effect,
and pull the wire out.
3.4 Removing the wire guide tubes in the event of a wire jam
- Fig. 10 -
If a wire jam has occurred in the area of the wire guide tubes, this can be eliminated more easily
by removing the wire guide tubes.
- Shut off the wire transport (move triangular handle
g until you see the feed wheels disengaged).
- Loosen the clamping screw
i
(slotted or Torx screw) and remove wire guide tubes
j
- Disentangle wire and remove from wire guide tubes.
- Press adjusting disk
d on wire return lock downwards in order to eliminate its clamping effect
and pull wire out.