Hohner M 45/6, Operating Instructions And Spare Parts List

Page: 33 / 45

Operation
Hohner Maschinenbau GmbH M 45/6 33
3.8 Spine centering parts
The centering parts are only used for saddle stitching. They serve to precisely position the staple
in the fold centre of the sheets (- cf. 15 -)
3.8.1 Installing the holding down device (standard version)
- Fig. 17 -
- In order to install the holding down device
, insert the guide pin into the borehole on the bender
and tighten the fastening screw .
3.8.2 Adjusting the holding down device (standard version)
- Fig. 17 -
The centering prism
can be moved back and forth by turning the adjusting screw .
- Move the centering prism backward or forward until it is precisely aligned with the prism of the
slider .
- Adjust the height of the prism (approx. 0.5 mm above the clincher box) by moving it in the slot
and tighten the fastening screw .
3.8.3 Installing the holding down device (optional narrow version)
- Fig. 16 -
- In order to mount the holding down device, screw the spring bolt
into the borehole on the
stitching head.
- Insert extension spring into spring bolt and lifting rod .
- Fix holding down device by screwing fastening screw to lifting rod and flange bushings
on the stitching head.
- Make sure that the lifting rod moves smoothly.
- Installing the carrier
in the main slide bar - see SPARE PARTS LIST page E27.
3.8.4 Adjusting the holding down device (optional narrow version)
- Fig. 16 -
The centering prism
can be moved back and forth by turning the adjusting screw .
- Move the centering prism backward or forward until it is precisely aligned with the prism of the
slider .
- Adjust the height of the prism (approx. 0.5 mm above the clincher box) by moving it in the slot
and tighten the fastening screws .