14
Step #11: The last connection to the Slave (front) amplifier is to the second set of
speakers in your system.
If using Hogtunes lids
: the harness that comes with the lids will
work its way up the bike, and plug right into the amplified out “pigtail”
on the Slave (front) amplifier.
If you are installing this on a Road Glide Ultra and have the Wild Boar
Audio “WBAURH” Ultra Rear Harness, please go to the manual that
came in that box.
In all other cases (such as lower glove box speakers) you will use the
“ACC” harness that came in this kit that has a 4 pin black plug on
one end, and no plug on the other. This will plug into the amplified out
“pigtail” on the Slave (right side) amplifier and you will “hardwire”
your second set of speakers to this harness. The wires on the supplied
ACC harness are clearly labeled which will make wiring easy, but to
avoid unnecessary warranty calls, please take EXTRA CARE of joining
the wires together.
Step #12: If your comfortable removing and re-installing the fuel tank, the wires
can go in the factory wire “chase”. Alternatively, you can loosen the
tank’s “chrome console” and run wires up and over the gas tank, but
under the tank’s chrome console. There is a provision on the front of
the tank console for wires to pass.
NOTE:
During some routine bike
services, the fuel tank will be removed. Having the wires going up and
over the tank could be an inconvenience for the technician.
Step #13: Attach the amp’s brown wire to the negative (-) battery terminal and
the amp’s red wire to the positive (+) battery terminal. The factory
battery wires are also re-installed at this point. When attaching the
power and ground wires, it is always a good practice to do the
negative first. When the positive connector touches the battery, some
sparking is normal. This is a function of the capacitors in the amplifiers
charging up.
This amplifier comes set up to power front speakers and
speakers either in lids, or fairing lower glove boxes only. If you
are installing this amplifier on a Road Glide Ultra, you will need
a Wild Boar Audio “WBAURH” Ultra Rear Harness if you want
to power speakers in factory rear speaker “pods”, and have the
radio’s fader function properly.
