Step #6: Locate the “Fader/No Fader” switch on the side of the amp and make
sure it is in the “Fader” position. In this position, the amplifiers front and
rear channels are controlled independently by the Ultra radios built in
fader.
Step #7: Locate the “Rear Speaker Selector” switch also on the side of the
amp and make sure the switch is in the “A” Position. This is the best
performing amplifier setting for the rear speakers on Ultra Classic
models.
Step #8: The power harness ends in a black plug with 1 larger (10awg) red
wire, 1 larger (10awg) black wire. Locate this and plug it into the
matching black “pigtail” on the amplifier. The input harness has a
smaller black 8 pin plug with smaller gauge wire. Plug this into the
socket on the amplifier marked “hi level input”. Locate the 4 pin black
plug with black/brown and black/blue wires and plug into the
“front out” on the amp.
note: there is a blue socket labeled “bypass out”. this
carries the radios built in power (front channels only) and
although not used in this kit, it is there for plug and play
future system expansion.
For ‘00-’05 Bikes
, the supplied hook/loop is used to secure the
amp to the top of the radio. Position the amplifier as far back as it will go
so the outer fairing can go back on.
For 06-13 bikes
, the amplifier
mounts inside the fairing “over” the radio using the side plates shown
below. Before proceeding, make sure you have all the required
harnesses plugged in before mounting the amp. The side plates are
attached to the side of the amplifier by removing 4 screws on each side
of the amp, positioning the plates as shown below and re-installing the
screws into the amp. Factory CB, XM, and other similar modules are
mounted on top of the radio and secured with a screw that goes into the
back of the radio. Remove the screw and let the module(s) hang for now.
Do not install the module shelf yet!
Each side of the radio has 2
large allen head bolts that secure the radio into the fairing. You will loosen
the bolts on each side that are farthest away from you (closest to the inner
fairing) and remove the bolts closest to you. The amp will “clip in” to the
back bolts and the bolts removed will go back in over the plates to secure
the amp. Re-tighten all 4 bolts to factory specs. Install the module shelf as
shown, noting that the “stove bolt” heads must be positioned as shown.
Your module(s) will screw into the shelf using the factory screw(s) you
removed from the back of the radio.
3
Summary of Contents for REV 450U KIT-AA
Page 1: ......
