5
routing the main wire harness
Step #1: The power/ground harness and rear harness will pass together under
the inner fairing where the main wire harness passes through on the
brake side of the bike. Loosen the tank’s “chrome console” and run
wires up and over the gas tank, but under the tank’s chrome console.
There is a provision on the front of the tank console for wires to pass.
Stock Harness and Amplifiers Harnesses
Passing from Fairing to Just in Front of Tank
(arrow a)
. Cable Tying the Harnesses To The
Main Bike Harness Just In Front Of The Tank
(arrow B)
Allows The Amp Harnesses To Go
Up Towards The Tanks Chrome Console Easier
And Makes For a Cleaner Install.
When correctly installed, the power and ground wires are the right
length to connect to the battery and if used, the rear wire 8 pin harness
is the right length to be zip-tied to the brake side fender strut. Be sure to
run the 8 pin harness
UNDER
the air line for the brake side rear shock.
please run the power harness as per the manual. Sometimes
people assume they know more than us and wire amplifier power
to the headlight wires or other places. not only will your friends
laugh at you, but you will be calling us for technical support.
please save us all from the grief and phone call!
Step #2: On the 8 pin rear harness “end” you will see 2 pairs of black
shorter wires in a sheath and 2 pairs of black longer wires in a second
sheath. Put the ends of the shorter wires into the brake side rear
speaker box. These wires will enter where the factory wires enter the
rear speaker box. Plug the factory rear speaker wires into the male
wires of the amp harness noting they will only go on one way.
note: the factory female rear speaker connectors are
non-insulated. once the factory female rear speaker
connectors are plugged into the Hogtunes male connectors,
wrap each connection with electrical tape to prevent the
positive and negatives from touching each other.
Take a Hogtunes rear speaker (model 352R-AA) and plug the female
connectors of the amp harness into the speaker. They will only go one
way. Repeat this step using the longer wires on the clutch side of the
bike.
a
B
Summary of Contents for REV 450U KIT-AA
Page 1: ......
