
62
General Maintenance
Sonic Meter Belt Tension Frequency
Specifications:
UHP Pump Belt Tension Frequency
New Belt = 51-54 Hz
Used Belt
(more than 20 hours of operation) = 44-47 Hz
Blower Belt Tension Frequency
New Belt = 76-80 Hz
Used Belt
(more than 20 hours of operation) = 65-69 Hz
Refer to the belt manufacturer’s manual for addi
-
tional maintenance information on the drive belts.
Drive Belt Adjustment
The UHP pump and vacuum blower are on ad-
justable mounts. A threaded adjusting bolt on
the vacuum blower mount is used for adjusting
the blower drive belt. Two adjusting bolts on the
pulley end of the UHP pump mounting frame are
used to adjust the UHP drive belt.
Typical Gates Sonic Tension Meter
Drive Belt Adjustment Procedure:
Blower
1. Loosen the four bolts in the slotted holes on
the mounting plate just enough to allow the
plate to move. Make sure not to loosen them
too much.
2. Rotate the adjusting bolt on the blower mount
to adjust the belt to the proper specification.
Use a spring scale tester or sonic tension meter
to achieve proper tension.
3. Check the pulley alignment with a straight
edge against the outside face of the drive and
driven pulleys to make sure the pulleys are
parallel.
Summary of Contents for Stripe Hog SH5000
