50
Operator’s Manual
Operations
monty universal 2
5.2.1-4
1
3
2
•
Hold the control down for the entire time in which
you wish to vary the angle.
Lower bead breaking
To break the second bead proceed as follows:
Figure 5.2.1-4
•
Activate the control
1
to bring the Bead Breaker Arm
outside its work zone.
•
Pull and hold the pin
2
, then rotate Bead Breaker
Disc set upwards.
•
Release the pin
2
.
•
Use the control
3
to lower the Disc until it is brought
under the tire.
•
Bring the Bead Breaker Arm into the working position
via the control
1
.
•
Raise the Disc into the lower wheel side Bead
Breaking position via the control
3
.
WARNING: CHECK THAT THE DISC IS CORRECTLY
POSITIONED ON THE SIDEWALL OF THE TIRE,
NEXT TO THE RIM
•
Activate rotation and lubricate the bead breaking
zone.
•
Proceed with bead breaking as described for the
upper bead by activating the disc ‘up’ control as
opposed to the disc ‘down’ control.
WARNING: IF NECESSARY BEAD BREAKING CAN
BE AIDED BY USING THE BEAD BREAKER DISC
PENETRATION ANGLE VARIATION CONTROL
Note
: The disc penetration angle variation control
can also be used for the lower bead.
