EN
.
6
Brown = main supply 230 Vac = line L
Black & Black = room thermostat = I-O
See above picture for the receiver internal connections.
I
MPORTANT
:
the link-wire (if fitted) must be removed from room
thermostat terminals
I
MPORTANT
:
Secure the receiver wiring harness to the internal
boiler cable anchors.
I
NSTALLATION OF RECEIVER
Secure the receiver in the proximity of the boiler using the
screws and wall plugs or using the adhesive magnetic strips
on the external boiler casing including to fix (both fixing tools
are provided).
The location should be chosen in order to see the receiver
light/button. For no reason should the receiver box be opened.
The appliance can only be mounted indoors and in areas free
from any water or moisture. Wiring must conform to IEE
regulations. RF Address Code Setting, if there is another user
nearby, e.g. in the next dwelling, you receiver may be operated
in error by their transmitter. You may select a different RF
address code to prevent this. (see encoding section).
N
OTE
:
do not fix the receiver in a permanent way to the boiler
casing.
I
NSTALLATION OF TRANSMITTER
The receiver and the transmitter are delivered already coupled
therefore the encoding procedure is not necessary at the
installation. In case it is required to encode the transmitter and
the receiver, this operation should be done while the receiver
and the transmitter are still very near (see the encoding
instructions).
Before fixing the transmitter check that the radio signal is
active (if there is no communication the receiver will blink red
or green irregularly.
Because the transmitter uses radio waves to communicate
with the receiver, you should also bear in mind that metallic
objects can weaken or deflect radio signals: this includes steel
reinforced walls, filing cabinets, kitchen appliances, mirrors,
etc. The range of the Radiostat is 40 metres in open air, and
20 metres inside buildings, dependent on RF obstructions as
mentioned above.
Position the Radiostat on a wall surface away from
obstructions and direct heat sources or draughts, in a room
that is warmed by the heating system. The fixing of the
transmitter can be done either with screws and wall plugs or
with the double side adhesive depending on the wall surface
quality (both supplied). See the side diagram as reference to
drill the wall. Distance between 2 holes is 60 mm, drill hole dia.
5 mm.
In the case of using wall plugs,
the transmitter box must be
open to fix the screws to the
wall plugs from inside the box.
The opening of the transmitter
must be done pressing gently
the lower button and leverage
on the upper side. Fit the
supplied two batteries inside
the
transmitter
with
the
direction
as
indicated
