EN
.
4
1. Rotate to select the desired temperature and press to enter.
2. Press once to activate or deactivate the ADVANCE function.
Use to “advance” the heating to an ON or OFF period
3. Press for 3 seconds to enter menu. Rotate to scroll through
the menu choosing between status mode, economy
temperature setting, time of day, day of the week,
programmed times day by day, technical menu (PL) and
exit. Press again to modify selected item.
Status mode:
rotate to change the thermostat mode
between AUTO, PARTY, and OFF, press to save. The
press from status mode automatically escapes from menu.
Economy temperature ECOt:
Rotate to select the desired
economy temperature and press to enter. This temperature
is used when programming time is OFF in AUTO status
mode.
Time of the day:
rotate to change the hours, press to save.
Move to minutes; rotate to change minutes, press to save.
Day of the week:
rotate to change the day, press to save
Programmed times day 1-7:
rotate clockwise to set hour
ON, rotate anticlockwise to select hour OFF. Clockwise and
anticlockwise rotation move ahead the time. Press to save.
Rotate clockwise to move to the following day. It is possible
to program together days 1
…
5 and days 6-7 with the same
pattern in a single operation.
PL:
rotate to select the password value, press to enter
inside the technical menu. Rotate to select the parameters:
01 = calibration of the temperature sensor, 02 = frost
protection temperature selection, 03 = hysteresis OFF value
selection, 04 = hysteresis ON value selection, 05 =
encoding and coupling with the RF receiver, 06 = radio
frequency value selection, EHIt = escape from technical
menu. (for technical menu see dedicated paragraph).
Exit
: escape from main menu.
I
NSTALLATION AND OPERATING INSTRUCTIONS
Unlike the conventional thermostat, this control separates the
function in two units. The receiver serves for wiring
connections and heat on/off control. The transmitter serves as
the user interface and for temperature sensing/control. The
two units are linked by radio frequency (RF). The RF
communication is only in one direction from the transmitter to
the receiver, therefore the transmitter does not receive any
feedback from the receiver, no alarm of missing
communication is visible on the transmitter display.
T
HE TRANSMITTER
is a wall-mounted
timer-thermostat. The transmitter can be
located wherever a conventional room
thermostat would normally be sited. No
wiring is required, as the transmitter is
battery powered.
T
HE RECEIVER
is connected to the boiler,
and
can
replace
a
conventional
mechanical or electronic time clock. The
receiver arrives pre-cabled and ready to
be fixed, therefore it is not necessity to
open the receiver casing. The receiver is
equipped with a transparent bubble
button that incorporates the button
function, the green led function and the
red led function.
Button functions:
1. Press once: manually switch ON the heating (relay closed),
press again to switch OFF.
2. Press for 5 seconds: encoding procedure start up. After
success coupling there is an automatically exit from the
procedure.
