HOFFEN POJM200548, Instruction Manual

Page: 28 / 34

3
28
7. During operation, the light indicators show the air vacuuming and heat sealing
process, and the operation sound is clearly heard.
8. If you want to stop the process before it ends, press the STOP button.
9. After a few seconds of operation, the light indicators will go off.
10. Press the top lid release buttons to remove the bag and check if the foil has been
sealed properly.
7.5 Cutter function
1. Make sure the top lid of the device is closed.
2. Spread the foil on the lid.
3. Hold the bag end with one hand so that it stays still. Then slide the foil cutter
knob with the other hand. The cutter blade can cut the foil in both directions.
CAUTION! Risk of injuries. Observe particular caution during cutting!
7.6 Device overheat:
Caution! If the DRY / SEAL / VAC_SEAL function indicators start flashing simul -
taneously after a long period of operation, it means the overheat protection has
been triggered.
Disconnect the device from the mains.
Wait approx. 5-10 minutes for the device to cool down.
The device can be started in the normal operation mode if the LEDs stop fla -
shing. The device can be operated again only if the LEDs are not flashing.