HOBO TidbiT MX Temp 400 (MX2203) and Temp 5000 (MX2204) Logger Manual
1-508-759-9500 (U.S. and International) 8
www.onsetcomp.com
1-800-LOGGERS (U.S. only)
4.
Remove the battery and place a new one in the battery
holder, positive side facing up.
5.
Inspect the O-ring on the battery cover. Make sure it is
clean and seated properly. Remove any dirt, lint, hair, or
debris from the O-ring. If the O-ring has any cracks or tears,
replace it as follows:
a.
Spread a small dot of silicone-based grease on the O-
ring with your fingers, making sure the entire O-ring
surface is completely covered in grease.
b.
Place the O-ring on the cover and clean off any debris.
Make sure the O-ring is fully seated and level in the
groove and not pinched or twisted. This is necessary to
maintain a waterproof seal.
6.
Place the cover back on the logger, lining up the unlock icon
(if applicable) with the double-ridge on the side of the
logger case (shown in step 3). Make sure the cover is level
as it is placed on the logger case to ensure the battery
terminal maintains its proper position.
Battery Cover Placement Top View
7.
While pushing down on the cover, rotate it clockwise until
the tab is aligned with the double-ridge in the logger case. If
your cover has lock icons, then rotate it so that the icon
moves from the unlocked to locked position. When the
cover is properly positioned, the tab and the locked icon (if
applicable) will be aligned with the double-ridge in the
logger as shown.
8.
Place the logger back in the protective boot, making sure
the double-ridge in the logger case slides into the groove on
the inside of the boot.
Note:
MX2203 logger is shown in the example; the groove in
the boot on an MX2204 logger is in a slightly different location.
WARNING:
Do not cut open, incinerate, heat above 85°C
(185°F), or recharge the lithium battery. The battery may
explode if the logger is exposed to extreme heat or conditions
that could damage or destroy the battery case. Do not dispose
of the logger or battery in fire. Do not expose the contents of
the battery to water. Dispose of the battery according to local
regulations for lithium batteries.
Cover aligned properly
Place cover
straight down and
level on the back
of the logger
Battery Cover Side View,
Incorrect Assembly
Battery Cover Side View,
Correct Assembly
Make sure this double-ridge on the
logger slides into this groove on
the boot
