13. Put 2 pieces of long wood strip into the 330*4 slot.
14. Stick it with 502 glue.
15. Put the horizontal tail into the fuselage and stick them to make sure they are
symmetrical.
16. Assemble the main aircraft wing and horizontal tail correctly, and make sure A=B as
well C=D.
17. Stick one plastic servo horn to the vertical tail with 502 glue and make sure the
distance between servo horn and the lower part of the vertical tail should be 92mm.
18. Cut a slot in the edge of vertical tail with craft knife, insert half-size of the 4 pieces of
paper hinge into the stick, then stick them with 502 glue.
19. Cut a slot in the fuselage after insert the paper hinge, stick them with 502 glue.
20. Stick the plastic servo horn to the position illustrated in the picture.
21. Cut a servo hole in the fuselage and make sure the servo hole is at a distance of 13cm
from tail angle.
22. Connect servo connecting rod carbon rod to steel wire with hot shrink tube.
23. Make sure the angel between connecting rod and servo arm should be vertical. After
adjust the length of connecting rod, drop 502 glue into the seam of hot shrink tube to stick.
24. Stick the wood strips of motor mount with 502 glue.
