25. Inset the head of fuselage then stick it with 502 glue. 26. Put landing gear steel wire
into the hot shrink tube after it fixed with wheel, then stick the tube with 502 glue.
27. Insert the landing gear into the fuselage, then insert the wood stave into the se<am
then stick with 502 glue.
28. Fix the motor to Plywood Motor Mount with self-Tapping Screws.
29. Refer to the position of receiver
30. The centre of gravity should be 120-130mm from the front edge of aircraft wing.
31. We suggest that you add 1- 2 degrees of right-thrust, which can be achieved by adding
one washer or two behind the top and right side of the motor (between the motor and the
motor mount). When set properly, the trim for the elevator and the rudder should be
neutral. Fine-tune the down-thrust and right-thrust until this trim is achieved. When doing
flight test, we suggest you should keep the flight balance according to the centre of gravity
we recommend. When doing 3D flight test, you can move slightly the centre of gravity
backward.
General flight:
Aileron: 20 degrees, Elevator: 20 degrees, Rudder: 20 degrees.
3D flight:
Aileron : 45-55 degrees, Elevator: 45-60 degrees, Rudder: 45-60 degrees.
Seek Assistance:
If you are a beginner in the R/C field, we suggest you turn to an
experienced pilot for help with the first few flights.
E-Mail:
RED EAGLE MODEL
www.wxhymx.com
Made in China
