Assembly Instructions
3
.
Attach the aileron wires
.
Since there are two ailerons (1 on each wing) but both are controlled together by a single
channel, they will need to be connected to a cable with a single end. Once you have the aileron
wires ( from the aileron servos) for both wings pushed into the fuselage, connect the Y split
cable as shown.
4
.
Attach the aileron
servo to the aileron
.
In order to control the movement of the aileron on both wings, you will need to attach the
aileron servo's push rod/clevis to the control horn using the linkage rod as shown. This is as it
appears on the underside of each wing. Make sure to secure the control horns with the
supplied screws and backing plates
5
.
Install the propeller
.
Make sure to push the propeller all the way in and to secure it using a tool to tighten the
propeller nut.
0
4
Y Split
Goes into
receiver's Channel
1, Aileron
Aileron Servo wires
(These wires are from the wings)
Control Horn
Servo
Servo arm
Repeat for the other wing
Linkage rod
Aileron
Must be positioned this way with the
control horn's holes facing towards the
nose of the glider