4. Remove the two canopy screws and the canopy. Under the canopy is the
canopy LED strip that must be unplugged from the control board.
5. Remove the 3 screws holding the control board and remove the board.
6. Install the canopy LED strip and the canopy. Be sure that the post is supporting
the back of the LED strip.
7. Install the new control board and route the wires for motors. To prevent
damage to the wires, route them between the guides on the inside of the
arms.
8. Install the LED covers. Before tightening the screws, make sure the wires
are positioned so they will not be damaged.
9. Replace the motor covers.
10. Calibrate the quadcopter sensors.
BATTERY PRECAUTIONS
The Vista FPV uses a lithium polymer (LiPo) battery. Follow these
precautions to ensure safe and trouble-free operation.
•
ALWAYS disconnect the battery from the quadcopter when not in use.
•
Only use the included charger with the fl ight battery.
•
Do not attempt to use this charger with NiCd or NiMH battery packs.
•
Do not attempt to use a damaged battery.
•
This product contains a LiPo battery that must be recycled or disposed
of properly.
•
Do not leave the charger unattended while charging. Disconnect the
battery and unplug the charger immediately if either becomes hot!
However, it is normal for the charger to get warm.
•
Disconnect the battery from the charger and carefully move the
battery to a fi reproof location if the battery begins to swell or smoke!
•
Never allow the battery temperature to exceed 140° F [60° C].
•
Do not attempt to charge a battery if it is swollen or hot.
•
Do not place the charger or any battery on a fl ammable surface or
near combustible materials while in use.
•
Never disassemble or modify pack wiring in any way or puncture cells.
•
Never charge inside a vehicle.
•
Always disconnect the battery and remove the charger from the USB
port when not in use.
•
Land your model immediately when the LEDs fl ash to indicate that the
battery power is low. Recharge the battery before attempting another
fl ight. A dangerous situation can occur when attempting to recharge
an over-discharged battery!
•
ALWAYS keep a supply of sand accessible when charging. Dumping
sand on the battery will extinguish a LiPo chemical fi re.
•
ALWAYS KEEP OUT OF REACH OF CHILDREN
7
