6
3
ATTACH THE TAIL FEATHERS
4
PREPARE THE TRANSMITTER
Locate the horizontal stabilizer
(stab) and the vertical stabilizer (fin).
Carefully exercise the elevator and the
rudder two or three times to loosen
them up. CAUTION: Do not flex them
too far or too many times or they may
become weak.
Trial fit both parts into the slots at
the rear of the fuselage. Make sure that
the stab is straight with the fuselage
and the black control horn is pointing
up. Make sure the fin is perpendicular
to the stab.
When you are satisfied with the fit,
apply a portion of the glue provided to
the top and bottom of the stab and
reinstall into the fuselage. Next, apply
glue to the bottom edge and sides of
the fin and slide into place. Squeeze
the top of the fuselage against the sides
of the fin and against the stab.
Continually check the stab and fin
to make sure they are straight and true.
Hold the parts until the glue dries
(about 15 minutes).
Install eight new alkaline (AA)
batteries into the transmitter. Next,
carefully screw the antenna in until
snug.
Fuselage
(AA) Battery Compartment
(Located on the bottom)
Antenna
Vertical Stabilizer
(Fin)
Rudder
Elevator
Control Horns
(black)
Horizontal Stabilizer
(Stab)
Glue
(Use all of the
remaining glue)
Apply glue to the shaded areas on both sides of
the Stab and Fin. Allow the glue to become “dry to
the touch” before assembling.
