.
A complete Parts List is available at www.HobartWelders.com
OM-284833 Page 11
SECTION 4
−
SPECIFICATIONS
4-1. Serial Number And Rating Label Location
The serial number and rating information for this product is located on back. Use rating label to determine input power requirements and/or rated output.
For future reference, write serial number in space provided on back cover of this manual.
4-2. Software Licensing Agreement
The End User License Agreement and any third-party notices and terms and conditions pertaining to third-party software can be found at
https://www.hobartwelders.com/eula
.
and are incorporated by reference herein.
4-3. Information About Default Weld Parameters And Settings
NOTICE
−
Each welding application is unique. Although certain Miller Electric products are designed to determine and default to certain typical welding
parameters and settings based upon specific and relatively limited application variables input by the end user, such default settings are for reference
purposes only; and final weld results can be affected by other variables and application-specific circumstances. The appropriateness of all parameters
and settings should be evaluated and modified by the end user as necessary based upon application-specific requirements. The end user is solely
responsible for selection and coordination of appropriate equipment, adoption or adjustment of default weld parameters and settings, and ultimate
quality and durability of all resultant welds. Miller Electric expressly disclaims any and all implied warranties including any implied warranty of fitness
for a particular purpose.
4-4. Welding Power Source Specifications
Rated Welding
Output
Amperage Range
Maximum Open-
Circuit Voltage DC
Amperes Input At Rated Load Output, 60 Hz, Single Phase
208 VAC
240 VAC
KVA
KW
250 A, 26.5 volts DC,
40% Duty Cycle
30
−
280 A
40
62.6
55.7
12.6
9.4
200 A, 24.0 volts DC,
60% Duty Cycle
30
−
280 A
40
57.0
50.8
11.4
7.1
Wire Type and Diameter
Wire Feed Speed
Dimensions
Net Weight
Without Gun
Solid Steel
Stainless Steel
Flux Cored
Aluminum*
50
−
700 IPM
(1.3
−
17.8 m/min)
H: 30 in. (762 mm)
W: 19 in. (483 mm)
D: 40 in. (1016 mm)
205 lb
(93 kg)
.023
−
.045 in.
(0.6
−
1.2 mm)
.023
−
.045 in.
(0.6
−
1.2 mm)
.030
−
.045 in.
(0.8
−
1.2 mm)
.030
−
.047 in.
(0.8
−
1.2 mm)
*SpoolRunner 200 required for welding aluminum
4-5. Environmental Specifications
A. IP Rating
IP Rating
IP21
This equipment is designed for indoor use and is not intended to be used or stored outside.
IP21 2014
−
06
B. Temperature Specifications
Operating Temperature Range*
Storage/Transportation Temperature Range
-4 to 104
°
F (
−
20 to 40
°
C)
*Output is derated at temperatures above 104
°
F (40
°
C).
−
22 to 122
°
F (
−
30 to 50
°
C)
Temp_2016- 07
