Hobart CLF26D-10, Instruction Manual

Page: 8 / 16

INSTRUCTION MANUAL FOR DISHWASHERS
Page 7 of 15
GB
•
Perform the operations described in the paragraph “Washing cycle” again to run
subsequent cycles.
START
TANK BOILER
4.5.1 Infinite cycle (
∞
)
It is enabled by selecting the cycle indicated by the
symbol
∞
and pressing the start cycle button shown
at the side. The machine continues to wash. To start
the rinse and drain stages, press the start cycle button
again. The cycles stops automatically.
TANK
4.6 Turning off the machine
Press the on / off button as shown at the side (the
corresponding indicator lamp turns off).
4.7 Emptying the machine
4.7.1 Machine without discharge pump
Turn off the machine and remove the overflow. Wait for
the tank to become completely empty.
Turn off the machine every time the overflow is
removed. Clean the machine as described in the
chapter “Maintenance”.
TANK 4.7.2 Machine with discharge pump
1. With the machine on, keep the cycle selection button
shown at the side pressed until the indicator lamp
corresponding to the drain cycle turns on.
2. Remove the overflow and close the door.
START
BOILER
3. Press the start / start cycle button. The machine
turns off at the end.
4. Clean the machine as described in the chapter
“Maintenance”.
TANK
4.8 Resin regeneration
When the corresponding indicator lamp turns red, you
have to run a resin regeneration cycle in order to
restore proper operation of the internal water softener.
Proceed as follows:
•
Empty and clean the machine as described in the
paragraph “Emptying the machine”.
•
Open the salt container inside the tank.
•
Pour approx. 300 g of regeneration salt into the
container (kitchen salt without additives in 1 or 2-mm
diameter granules).
•
Close the container again with force.
•
Make sure that the overflow has been removed.