HMS M4208, Manual Instruction

Page: 18 / 29

Step 6
1. Connect the Console(N) wires with Console Mast(J) wires (See Picture 1).
2. Carefully tuck the wires into the Console Mast(J), then attach the Console(N) to the Console Mast(J) by using 4 pcs of
pre-set M5*10 mm screws, locking them with Wrench (5).
COMPUTER AND BATTERIES
Operation
1. Mode key under the LCD Display lets you to select and lock on to a particular function you want(scan
mode,time/speed/distance/calorie/ ODO/RPM/Pulse mode). Reset the data to zero by pressing the MODE KEY for several
seconds.
2. The processor turns off automatically when the speed sensor has no signal input or no key is pressed for approximately 4
minutes.
3. The LCD Display could be activated again by pressing the Mode key or riding the pedals for a circle.
Batteries
1. Remove the battery cover and insert 4 AA 1.5V battery into place at the back of the computer .
2. Pay attention to the polarity ( label located inside the battery compartment ), the battery cover back into position and make
sure it is well secured .
Notice:
- Used batteries should be replaced immediately
-
Batteries should be replaced at least one year in order to avoid leakage
Picture 1
MODE KEY
LCD
display
Baterie: 4ks AA 1.5V
Picture 1