HMS M4208, Manual Instruction

Page: 15 / 29

ASSEMBLY
Step 1
1. Po After place main frame in a flat level surface, put the main frame(A) upright slightly, then align and place rear stabilizer
tube(B) upon main frame, attach the two M8* 65mm bolt(1) to rear stabilizer tube(B) and main frame (as picture shows),
stack with two Φ8* 19 Washer(2) and two Φ8 Spring Washer(3). Tighten the M8*15mm nuts(4) by wrench(5).
2. To assemble front stabilizer tube(C) as above steps.
3. After finishing the assembling of Rear stabilizer tube(B) and front stabilizer tube(C), put Decorative cover(D) on them. Pls
be careful the Decorative cover must go though the strip groove. (See picture 1)
Step 2
1. Remove the three m8*
7mm nuts and three φ8 washers from the back the back of the seat(e).
2. Attach seat(e) to seat post(f), using wrench(5) to lock the three m8*
7mm nuts which have been attached with φ8 washers.
(see picture 1).
3. Pull the seat height adjustment knob outward while sliding the seat post(f) into main frame(a
). when you hear a “pa” after
loosening the seat height adjustment knob, tightening the seat post clockwise.
4. S
eat post(f) could be adjusted up and down to one’s comfortable height
by the above steps.
Step 3
1. Attach the right pedal(h) to right crank arm( with r label on them), and tighten it clockwise with wrench(5).
2. Attach the left pedal(g) to left crank arm( with l label on them), and tighten it counter-clockwise with wrench(5).
Picture 1
Picture 1