HMS BE4600-i, Manual Instruction

Page: 23 / 50

23
BE4600-i
Assembly Instruction
Please make sure there’s enough space to install the treadmill and recommend 2 persons to install it.
WARNING: Don’t insert the power wire until the treadmill was fully assembled.
STEP 1.
Assembling left/right upright tube and Base frame
A. Insert Left upright tube (4) to base frame (13), and attach four
Half-round bolts M8X16 (A19), one Half-round bolt M8X45 (A1),
and five Flat washers Φ8
（
C1
）
, Do not tighten all parts
provisionally (see figure 1)
B. Pull out the Signal wire (41) from the lower side to upper side of
the right upright tube(5) . (see figure 1)
C. Insert Right upright tube (5) to base frame (13), and attach four Half-
round bolts M8X16 (A19), one Half-round bolt M8X45 (A1), and five Flat
washers Φ8(C1), Do not tighten all parts provisionally (see figure 1)
STEP 2.
Assembling left and right upright tube with computer / handlebar
A. Connect the Signal wire (41) to corresponding wires that come
from computer/handlebar (10) ,and put the extra wires to the
right upright tube. (see figure 2)
B. Tighten the computer/handlebar (10) to upright tubes (4/5) with
six Half-round bolts M8X16 (A19), six Flat washers Φ8 (C1).
C. Screw up all the bolts of the step 1 and 2.