HMS Premium BE6000, Manual Instruction

Page: 57 / 96

Warning
The incline must be return zero and cut off power before folding.
Maintenance and malnfunction treatment
1.
Clean: The surface of the treadmill should be kept clean, pull out the power line before
cleaning. You can clean the running belt and the surface of the treadmill with a soft and wet
cloth.
2.
Adjust belt deviation: The running belt is adjusted at factory; it may runs defectively after
transportation and use. Turn off the treadmill before adjusting, (see figure) adjust the pull the
left and right bolts in rear roller with hex spanner. If the belt is deviation to left, clockwise
rotate the left bolt. If the belt is deviation to right, counterclockwise rotate the right bolt. It is
better to adjust ½ circle once. Then turn on the switch, check if the belt runs defectively when
the running speed is 4~5 km/h. Repeat to adjust to the belt in the center.(see figure).
3.
Adjust belt slip: After using for a long time, the belt may be longer and stuck. Your should
adjust the left and right bolts in rear roller clockwise at same position till the runs smoothly
and freely, it is better to adjust 1/2 circle once .But avoid to short belt using period of losses,
doing not to adjust it too tight.
4.
Lubricate: After using over 100hours or the lubricant between the running board and the
running belt is used up, please lubricate the running board and adjust the running belt well.