5
Figure 8.
Battery charging indicator lights
Figure 9.
Battery going into AC900 storage port
When a battery is fully charged and ready for
use, its red “Charging” light will go off and the
green “Ready” light next to it will go on.
CAUTION: Do not remove batteries from the charger until the green READY light
is lit, or the charger will reset and the charge cycle will begin again.
To remove a fully charged battery from the
battery charger, push the battery from the end
near the status lights.
Store fully charged batteries in the storage
ports on the right side of charger until you need
them, as shown in Figure 9.
CHARGING LIGHT STATUS TABLE – WITH BATTERY INSERTED
CHARGING LIGHT
WHAT IT MEANS
WHAT TO DO
Red blinks:
Either the battery or the charger has
2 times quick - 3 seconds off
a problem. Mark the battery and
Discharge error
retry in a different charging port.
The battery is faulty if it has the
same problem in a different port
AND a known-good battery passes
in the same ports. The charger
circuitry is faulty if a known-good
BATTERY fails in the same ports.
Red blinks:
3 times quick - 3 seconds off
Charging error
Red blinks:
4 times quick - 2 seconds off
Low-battery error
Red blinks:
5 times quick - 2 seconds off
Charging error
Green blinks:
2 second on - 2 second off
Read-write error
Green blinks:
3 times quick - 3 seconds on
Memory full
Red and Green blink alternately
Authentication error
