Remove a couple of pagers from the charger base.
At the range test menu, press “#” key to turn range test “ON”
Press “ENTER” to start the range test. As soon as range test is activated,
you’ll notice the IQ pagers flash once every 10 seconds. Walk around your
property. When you reach the point where the pagers do not flash
consistently, this is your maximum range.
Press the “CANCEL” key to stop the range test. Press the “CANCEL” key again
to exit the system programming menu.
4) Button Select (Factory Default: Function)
With this feature, you can select button function type.
(1) Open Table
If “Open Table” is set, “OPEN”, “BUS”, “CLEAR” and “EST” keys are available.
- OPEN, BUS, CLEAR: These buttons will display Table Status.
- EST: This button will setup Estimated Waiting Time.
(2) Preset Message
①
Beep
If “Beep” is set on, 4 buttons are recognized as “F1”, “F2”, “F3” and “F4” buttons
instead of OPEN, BUS, CLEAR and EST buttons and the buttons will be functioned
as Predefined Messages
②
Num Code
If “Number Code” is set on, 4 buttons are recognized as, for example, “11”, “22”,
“33” and “44” buttons instead of OPEN, BUS, CLEAR and EST buttons and the
buttons will be functioned as Predefined Messages
(3) Manager Pager
If “Manager Pager” is set on, 4 buttons are recognized as shortcuts of “Manager
No# 1”, “Manager No#2”, “Manager No#3” and “Manager No#4” buttons instead
of OPEN, BUS, CLEAR and EST buttons and the buttons will be functioned as
Predefined Messages
5) Set Pager Alert (Factory Default: Vibe Only)
With this feature, you have the option of changing the way your pagers alert the
guest.